Send the <#> command to receive the Microscan scanner model #. This will allow you to send the appropriate scanner config commands that correspond to that particular model.
Subscribe to:
Post Comments (Atom)
skip to main |
skip to sidebar
Blog Archive
-
▼
2005
(15)
-
▼
November
(15)
- Quadrus EZ vs Quadrus Mini vs MS-4
- How to choose the best linear scanner for your app...
- How to use I/O with 5 volt MS-3
- How to get a 5th preamble or postamble character
- How to set continuous read 1 output to infinite
- Wire colors for 61-000011-01 820 cable
- How to wire opto isolated outputs for 24 volt Micr...
- Reading Dot Peen Datamatrix after Chrome Plating
- Conifgure the Microscan slave for Daisy Chain
- How to use a hand scanner to program the new master
- Calibrating on Composite Codes with the Quadrus EZ
- Fixed symbol length on the Microscan 860
- How to retrieve the Microscan scanner model #
- How to read the Molex traceability pad with the Mi...
- How to use the Microscan 880 as an area scanner
-
▼
November
(15)
No comments:
Post a Comment